(30 minutes)
Make sure the rubber part around the lens is warmed
before trying to install lens.The lens fits in a groove in the rubber backing and if it is cold its very stiff. warming the rubber part helps the lens start right in this groove
2/28/2024 CLEMMONS, NC Gray
(3 minutes)
Remove two screws install lens in rubber gasket insert screws in bulb holder done.
12/25/2023 SUMMERSVILLE, WV Craig
(5 minutes)
Super easy and quick installation.
12/15/2023 LEXINGTON, VA Keith
Unrated
Easy and part matches OEM exactly.
8/11/2023 LENOIR, NC Rick
(10 minutes)
Remove rubber seal from tracker fender. This makes install easier to get the lip of the lens into the grove of seal.
6/20/2023 Ridgefield, WA William
(5 minutes)
6/8/2023 EVERETT, WA Consolidated
(10 minutes)
Male sure to clean out seating groove in rubber frame. If rubber too hard, consider soaking in very hot water for a few minutes to make it more pliable.
5/28/2023 DARTMOUTH, MA Christopher
Unrated
(10 minutes)
Use heat to stretch the black frame
1/29/2023 FAIRBURN, GA PATRICK
(5 minutes)
Simple installation
1/6/2023 Reedsburg, WI Dave
(5 minutes)
Reach under the fender to hold the Light assembly in place while you remove the screws,Pop the new lens in place while still holding the assembly. Screw together.
10/12/2022 ROCHESTER, NY Joseph
(5 minutes)
Reinstall rubber trim around new lens making sure rubber is well seated onto new lens. Support light bulb fixture from behind with free hand as you start screws. Don't over tighten mounting screws.
Make sure the rubber part around the lens is warmed before trying to install lens.The lens fits in a groove in the rubber backing and if it is cold its very stiff. warming the rubber part helps the lens start right in this groove
CLEMMONS, NC
Gray