(2 hours)
The original gasket has a metal race that will stay on the axle shaft. The new gasket doesn't require this, so be sure to remove it before putting the axle back together or it will not slide up enough to put the snap ring back on.
2/27/2023 ALTAMONT, IL Kevin
(5 hours)
Time consuming to get to the seal, must take the whole front wheel gear assembly apart.
4/11/2022 MOULTON, TX Rickie
Unrated
(2 hours)
Cleaning both castings was important because of light rust. Part of the old seal was still on the tractor upper spindle and had to be removed and the spindle cleaned. When replacing the front final drive casting the gear and splined shaft has to be aliened carefully so the unit can be pushed into place. Make sure the retaining ring is completely in the groove before releasing the casting. We used a small hydraulic jack with a 6" 2x4 on top to hold it place. Tapping down with a leather hammer on the top of the axel helped seat the seal correctly. sealed gear cover and filled with gear oil. No more leaks...
The original gasket has a metal race that will stay on the axle shaft. The new gasket doesn't require this, so be sure to remove it before putting the axle back together or it will not slide up enough to put the snap ring back on.
ALTAMONT, IL
Kevin