(15 minutes)
I used a punch and a deep socket to get the old one out and also to put the new one in.
8/16/2023 RUDY, AR Quin
Unrated
(45 minutes)
Set gasket then drive or press both gasket and bushing as assembly. My gasket was seized had to use heat to remove.
1/6/2023 PARADISE, TX Ben
(1 hour)
NH, TN-75, lower bar for 3pt. Carrier is tight to case. Use mallet to rotate carrier so ears can be used for leverage. Two people two pry bars to pull out. Assembly is easy but note the snap ring may be held in if bearing is not fully seated. Recommend new bearings if possible. Watch when assembling to ensure gasket is seated around spherical bearing so as to not damage during installation. Lube mating surfaces. Time is per side, you may make better time with these tips.
I used a punch and a deep socket to get the old one out and also to put the new one in.
RUDY, AR
Quin