Unrated
(10 minutes)
Installed two of these on the bearing shaft. They are a snug fit, but the shaft tapped into the bearings easily. I supported the inner race and literally tapped the shaft in with a small ball peen. I greased the bearings and then tapped the assembly right into the housing. Ensure you fill the cavity with grease after installation and installing the circlips.
Installed two of these on the bearing shaft. They are a snug fit, but the shaft tapped into the bearings easily. I supported the inner race and literally tapped the shaft in with a small ball peen. I greased the bearings and then tapped the assembly right into the housing. Ensure you fill the cavity with grease after installation and installing the circlips.
KANAWHA, IA
BC