(15 minutes)
Knock steering arm ball joint out first and slip part over steering arm. Put loctite on screws to help prevent vibrating loose again.
3/11/2024 MILAM, TX Daniel
(5 minutes)
If you still have any play after installing both side holder plates this means the hydraulic steering assembly mating surfaces also were worn and should be replaced. A cheat method is to loosen one holder plate at a time and with a five pound hammer tap the secured side holder a few times inward. Do this to both side holder plates. After resecuring both sides the assembly will be snug and the play should be gone.
5/27/2023 GALIVANTS FERRY, SC John
(5 minutes)
Support assembly by loosely installing the two holders brackets until you get the hydraulic lines connected. Seat the holder brackets into the groove on the cylinder and tighten the holder brackets adding lock-tight to the threads.
3/9/2023 SNOHOMISH, WA Tina
Unrated
(45 minutes)
Do this when your changing the tie rods or tie rod boot
Knock steering arm ball joint out first and slip part over steering arm. Put loctite on screws to help prevent vibrating loose again.
MILAM, TX
Daniel