Unrated
(20 minutes)
Remove by sanding or filing enough material where the bushing comes together so that it fits.
5/13/2023 Monroe, NC Mitchell
(3 minutes)
5/8/2023 FRIENDSVILLE, PA Thomas
(10 minutes)
first one used holder shaft as a driver and tapped with hammer to fully install. The 2nd one did the same but would only drive in two thirds of the way. Then put in press and applied 30 tons of pressure to no avail. i then cut off protruding one third and assembled with shaft and gauge
Remove by sanding or filing enough material where the bushing comes together so that it fits.
Monroe, NC
Mitchell