$<p>Messicks has over 50,000 Kubota parts in our Mount Joy warehouse. Our computerized inventory system enables us to have stock items packaged and at your door in a moments notice, or we can order in specialized items that may be less commonly used. We have taken the time to categorize frequently used parts so you can easily find common maintenance items for your tractor. If you need help finding specific part numbers call us at <b>877-260-3528</b> or email <a href="\">parts@messicks.com</a>.</p>$

#K2561-16600 SEAL KIT ***

Name: Kubota #K2561-16600 SEAL KIT ***
Brand: Kubota
SKU: K2561-16600
Price: 68.52 USD
Availability: InStock

$68.52

39 In Stock

Product replaces K2561-16560 K2561-16570 K2561-16580

Weight: 0.05 lbs

SEAL KIT ***

element not set

This part fits your tractor

This part fits 28 models

STEERING CYLINDER [COMPONENT PARTS]

More BX Series Tractors ...

STEERING CYLINDER [COMPONENT PARTS]

Installation Tips

Unrated
I did not have a thin 7/8 inch wrench to help in removing the ball joint from the hydraulic piston. After searching all over my small town I made one out of an old lawn mower blade and an angle grinder. I spent a lot less time doing it myself then I did going around town trying to find thin wrenches.

10/20/2024
Bascom, FL
Charles

(3 hours)
I removed the hood and cover plate to access the hoses. I drilled 7/32 holes which made removing the snap rings almost effortless. Save the time and heartache by getting a pickle fork for 10 bucks at HF for ball joints. Ball joints will laugh at your fruitless efforts with a prybar. I had to grind a couple of wrenches thin to get the tie rods off the cylinder shaft. Otherwise pretty straightforward.

5/22/2024
HAMBURG, NY
Peter

(3 hours)
Not terribly difficult…just tedious. If you are fortunate, the tire rod ends will separate easily so that the ram can be removed from the steering cylinder. In my case, the end of the ram without the flat for attaching a wrench separated first. Since I was replacing the tire rod ends as well, I ended up having to remove the stuck one by tapping the knuckle with an air chisel. Disassembly of the cylinder and installation of the seal kit went fairly smoothly thereafter. I drilled both ends of the cylinder as the service manual recommended to remove the retainer clips . Had to gently chisel out edge of old seals to remove and used a large socket to seat the new seals.

3/29/2024
PACE, FL
George

(2 hours)
Put in vise. Use a towl .Use a pick and screwdriver to get retaining rings out of each end tap the shaft out with wood and hammer. Take o rings out with pick. Clean inside where o rings go. Make sure u install the same way the collars came out. Not hard just time. Have someone help holding it back on tractor. The angle for the hoses to get on was a little tricky. All in all not hard at all. The seals were definitely bad. The oil just blew through and over the middle o ring. Thanks Messick's. Great prices and fast shipping.

4/22/2023
Vermilion, OH
TYLER

Unrated (1 hour)
Hardest part is removing lock ring from center cylinder seal in order to replace inner o-ring.

8/24/2022
CLINTON, TN
PHILIP

(2 hours)
Circlips are the hardest part of this installation not difficult

6/17/2022
CHAFFEE, MO
Ron

Show all 6