(30 minutes)
Remove the bracket holding the long shaft to the tractor frame. Then the entire shaft can be removed from the tractor. This makes it easier to remove the old roll pin and install the new one.
7/8/2024 HANOVER, NH DANIEL
(1 hour)
Spline on drive side is keyed.
6/13/2024 LANDENBERG, PA John
Unrated
(29 minutes)
I used the bucket to raise the tractor. A little grease on the splines and put it on the front axle first and slide it back
6/6/2024 New Castle, VA John
Unrated
(30 minutes)
Make sure you have new cotter pins and it went quickly. I did remove the mower deck for better access!
8/19/2023 Cromwell, CT MARK
(1 minute)
It's better if you have the deck off for this installation
Remove the bracket holding the long shaft to the tractor frame. Then the entire shaft can be removed from the tractor. This makes it easier to remove the old roll pin and install the new one.
HANOVER, NH
DANIEL