(10 minutes)
¾” wrench to loosen original nut
Flat blade screw driver to assist in removing connector. Insert new switch till plunger gently depresses. Tighten new switch nut and reconnect connector wiring.
8/30/2023 VONORE, TN KENT
Unrated
(15 minutes)
Unbolt the bracket holding the switch. This will give you access to remove the plug from the switch. Remove the switch from bracket after noting the depth of the switch in the bracket. Screw in the new switch to the same depth as the old one. Reattach plug. Bolt the bracket back in. You may have to rock the treadle pedal to get the clearance needed. There is a short pin on side of the bracket. Make sure it lines up and seats in the hole in the side upright mount (for lack of a better word).
¾” wrench to loosen original nut Flat blade screw driver to assist in removing connector. Insert new switch till plunger gently depresses. Tighten new switch nut and reconnect connector wiring.
VONORE, TN
KENT