#SBA050309012 SEAL

Unrated (15 minutes)
Just installed this on a Ford 1910 and it was amazingly easy. Piston removal was amazingly simple. I heated the seal in hot water and it slipped on the piston with medium effort with the piston resting on a workbench. Big lip of the seal to the front of the tractor and everything was back together in 15 minutes. I replaced the O-rings too but probably didn't need to. These are the two O-rings needed for the job: O RING (SBA052310700) ORING (SBA052300900) No more 3-pt dropping or being jerky... smooth as can be now. I should have done this a year ago!

5/16/2024
MUMFORD, NY
Jae

Unrated (5 minutes)
heat seal in water until temp is 140 degrees, coat piston and seal with hydraulic fluid, hold piston in vise, press seal in groove on one side and continue pressing with thumbs to go over the top.

2/21/2024
MIDDLEBURG, FL
Robert

(25 minutes)
Used plastic bicycle tire levers and WD40 to pop the ring on. The side with wider lip should be installed facing toward front of tractor. Lift 3pt arms slightly to reinstall cylinder.

5/10/2023
WAKEMAN, OH
Supermoon

(1 hour)
Have something to keep the lifting arms from falling down all the way. They will need to be somewhere in the middle to allow the parts to go back together. Or have another person lift the arms when putting the unit back into the tractor.

9/20/2022
BIRMINGHAM, AL
Erich

(30 minutes)
Use edge of tailgate for leverage to get the seal the edge of piston without using sharp tools.

7/22/2022
SAINT CHARLES, MO
Christopher

(45 minutes)
Make sure nothing is hooked to 3 point. Only have one chance to install correctly so make sure to have seal lip facing front of tractor. Also order the o rings for the cylinder cover

6/3/2022
MONROE, NC
Blacks