#70848 6 X 3/4 B GRV SH

(2 hours)
I recommend that you remove the center section of the finish mower. Once removed, turn it over and remove the larger nut holding the pulley on, the pulley does not require a puller. The seal can be removed by using two 1 inch self taping screws on the edge of seal, but be careful not to drill too deep, take a claw hammer and remove the seal just like a nail. Clean it up and reinstall the new seal, make sure you bottom it out in the housing. Gear oil is going to come out, make sure you top it off when your done 80W90 and remove the side plug to make sure you do not overfill.

3/26/2025
MERIDIAN, MS
JERRY

Unrated (30 minutes)
Make sure to remember there’s a retaining ring holding that in

5/7/2024
MORGANTOWN, WV
CLIFFORD