#74075 Electric PTO Clutch for Woods F & FZ Mow'n Machine Models

(1 hour)
If the old clutch's bearing has failed as ours did, you will likely have to remove the flywheel flange shaft assembly and use an arbor press to ren\move the old unit from the shaft. Reinstall the flywheel flange/shaft assembly first as access to the (5) allen cap screws that secure it is limited when the clutch is installed. The clutch assembly barely fits between the rear frame interior and the shaft end, but it does fit, just be careful when positioning it. Be sure to follow the instructions that pertain to your model as the stay position is different depending on which series it is. Clean and properly secure the cable going to the electromagnet to be sure it cannot contact any rotating parts. Torque to specification and re check after 3-5 hours of operation.

8/3/2023
Sunbury, PA
FRED