Woods >
8345
Woods #8345 Headless Pin 1.00 in (HDLS)
$17.11
3 In Stock
Weight: 1.00 lbs
Woods 8345 - PIN HDLS 1.00 X.
Notes: “HDLS” is an abbreviation for headless. Size is shown as 1.00 (as listed).
Also referred to as a headless pin.
element not set
This part fits your tractor
This part fits 149 models
More Batwings ...
Installation Tips
80W-90 SAE Gear Oil - 1QT
Part# 76927DX6US
35
in Stock
$8.52
Tutela Lithium Grease, 14 ounce
Part# 77014BUYUS
69
in Stock
$6.68
Stainless Steel 1-1/4" Scraper
Part# 77700-02478
5
in Stock
$7.95
70 Piece Grease Fitting Assortment
Part# PERFW5215
3
in Stock
$16.53
1:64 1983 Ford 6610 – High-Vis Yellow
Part# 48090-C
1
in Stock
$6.99
Magnetic Parts Tray with Vinyl Magnetic Base
Part# 77700-02476
68
in Stock
$4.01
1:16 Farmall F-20 - 100th Anniversary
Part# ZFN44303
16
in Stock
$100.90
Cargo Control Kit
Part# 77700-12957
1
in Stock
$381.89
Telescoping Magnetic Pickup Tool (Kubota Brand Shop Tools)
Part# 77700-02479
20
in Stock
$5.02
- Roll Bar Tool Carrying System
Part# RACKS360
9
in Stock
$139.99
1X6" SAFTEY PIN
Part# 87298894
5
in Stock
$46.12
80W-90 SAE Gear Oil - 1QT
Part# 76927DX6US
35
in Stock
$8.52
Tutela Lithium Grease, 14 ounce
Part# 77014BUYUS
69
in Stock
$6.68
Stainless Steel 1-1/4" Scraper
Part# 77700-02478
5
in Stock
$7.95
70 Piece Grease Fitting Assortment
Part# PERFW5215
3
in Stock
$16.53
1:64 1983 Ford 6610 – High-Vis Yellow
Part# 48090-C
1
in Stock
$6.99
Magnetic Parts Tray with Vinyl Magnetic Base
Part# 77700-02476
68
in Stock
$4.01
1:16 Farmall F-20 - 100th Anniversary
Part# ZFN44303
16
in Stock
$100.90
Cargo Control Kit
Part# 77700-12957
1
in Stock
$381.89
Telescoping Magnetic Pickup Tool (Kubota Brand Shop Tools)
Part# 77700-02479
20
in Stock
$5.02
- Roll Bar Tool Carrying System
Part# RACKS360
9
in Stock
$139.99
1X6" SAFTEY PIN
Part# 87298894
5
in Stock
$46.12
To install on batwing mower, you need to take the load off the pin to R & R. Raised both wings. Locked the other wing in the up position. Then attached a chain to both wings & let down the wing to be serviced until the pin was free & could be rotated by hand. Removed the cotter pin & pushed out the old pin. Pushed in new pin & replaced the hardened washers as needed. Always use new cotter pins, I like the Mil Spec cotters from McMasters & Carr as I have had these cotters break while mowing.
DENVER, CO
KIM