Unrated
Very simple installation. You can reach up under the dash and pop the plastic OEM cover off. The factory plug is zip tied to the harness. Simply remove the zip tie, pull the plug up through the hole, plug in new switch then push switch down until it clicks into place. That’s it.
1/27/2024 LUNENBURG, MA Cam's
Unrated
(10 minutes)
The L-4060-LE is pre-wired on the right side of the dash as you are looking while seated.
Take your hand and push out the knock out panel. Locate the reusable zip tie and press down on the button to release the tie.
Push the wire plug up through the knock out and attach the control button. Put cruise button in the knock out hole and push down. Mission Complete!
4/26/2023 FAYETTEVILLE, WV Breezeview
(30 minutes)
It worked exactly as described. You have to squeeze the reusable zip tie just right to make it release. My protective cap for the harness was off probably from bouncing down our road. but the product was worked perfectly.
4/15/2023 Ulm, MT Handu
(5 minutes)
Installed on a Kubota L4060 limited edition. Super easy to install, the wire harness is there under the blank. Just pop the blank out, pull the harness up, plug it in and you’re done.
4/14/2023 GOSHEN, KY William
Unrated
Installed in my 3560 limited easily and works great. Great upgrade for the cost.
3/3/2023 EL RENO, OK Mike
(5 minutes)
pop out the blank, wiring harness is right below the opening, pull the wire up through the opening to make it easy to plug in the wire and then just feed the switch in to the opening and snap it in. Done. Plug and play.
8/5/2022 SPRING HILL, FL Marty
(5 minutes)
This button installs on the Grand L Limited Edition machines to the right of the steering column. All the wiring is already in place. You just pop out the cover on the dash, release the harness from the zip tie, plug in the harness to the back of the switch, and then insert the button into the dash. Super easy and well worth it to be able to set the speed and go when running a mower or similar implement.
7/18/2022 SUMMERVILLE, GA Bob
(3 minutes)
5/27/2022 MARS, PA GEORGE
(4 minutes)
It is the only connector under the dash that will fit the cruise control switch. Loosen the zip tie by pinching the connection area, pull out the connector, pop out the protective cover, slide in the cruise switch and plugin. The switch might seem loose in the slot. There is a small metal shield that can be removed on the switch to allow a tighter fit. After I removed that the switch fit snuggly into place.
4/27/2022 LA GRANGE, TN Jeremy
(6 minutes)
The zip tie that holds the wiring harnesss pigtail for the Cruise control button is held by a reusable zip tie. Just reach up under the dash right below the switch location and you will feel the black zip tie. Just hold back the little tab on the zip ties and release it. Then just feed the pigtail up through the hole and plug into switch. Really very straight forward
Very simple installation. You can reach up under the dash and pop the plastic OEM cover off. The factory plug is zip tied to the harness. Simply remove the zip tie, pull the plug up through the hole, plug in new switch then push switch down until it clicks into place. That’s it.
LUNENBURG, MA
Cam's