Steiner >
81-B039
#81-B039 B39 V-Belt for PTO Drive
$45.17
34 In Stock
Weight: 0.42 lbs
Steiner 81-B039 B39 belt (V-belt), used as a power take-off (PTO) drive belt on select Steiner and Jacobsen machines.
Common applications include the Front Hitch and PTO / PTO and Front Lift sections on Steiner 410, 415, 420, and 430 series tractors, and Jacobsen 4300 series units.
element not set
This part fits your tractor
This part fits 20 models
Installation Tips
1 Quart Trans-Hydraulic Oil (Transmission & Hydraulic Fluid)
Part# 15-012
100+
in Stock
$10.69
Fast Orange Hand Cleaner - 7.5oz
Part# FAST25108
13
in Stock
$3.14
3.5 Gallon Trans-Hydraulic Oil for Hydraulic Systems & Transmissions
Part# 15-015
22
in Stock
$114.85
Performance Tool Hex Head Drill Screw Set - 200pc
Part# PERFW5220
3
in Stock
$15.01
70 Piece Grease Fitting Assortment
Part# PERFW5215
6
in Stock
$15.97
Deluxe Steering Wheel Spinner Knob for Tractors
Part# 77700-01540
100+
in Stock
$13.23
Kubota Stainless Steel 1-1/4" Scraper
Part# 77700-02478
7
in Stock
$7.95
Kubota Mini Lever Action Grease Gun
Part# 77700-03644
4
in Stock
$30.14
RACKS360 - Roll Bar Tool Carrying System
Part# RACKS360
12
in Stock
$139.99
1 Quart Trans-Hydraulic Oil (Transmission & Hydraulic Fluid)
Part# 15-012
100+
in Stock
$10.69
Fast Orange Hand Cleaner - 7.5oz
Part# FAST25108
13
in Stock
$3.14
3.5 Gallon Trans-Hydraulic Oil for Hydraulic Systems & Transmissions
Part# 15-015
22
in Stock
$114.85
Performance Tool Hex Head Drill Screw Set - 200pc
Part# PERFW5220
3
in Stock
$15.01
70 Piece Grease Fitting Assortment
Part# PERFW5215
6
in Stock
$15.97
Deluxe Steering Wheel Spinner Knob for Tractors
Part# 77700-01540
100+
in Stock
$13.23
Kubota Stainless Steel 1-1/4" Scraper
Part# 77700-02478
7
in Stock
$7.95
Kubota Mini Lever Action Grease Gun
Part# 77700-03644
4
in Stock
$30.14
RACKS360 - Roll Bar Tool Carrying System
Part# RACKS360
12
in Stock
$139.99
Remove lower pulley and remove bolt holding pivot arm of idler. Slip belt into place , then replace idler arm bolt (make sure to have the large washer/spacer in the same location as it was. This arm must be able to move. Then I replaced lower pulley. I had to add a couple washers to align the lower pulley with the idler .
SPRINGFIELD, PA
ANDREW